Metro Water Treatment
We are providing solutions for metro water treatment Chennai for Commercial and Industrial Reverse Osmosis Water Treatment Plant. Also we provide High-quality water treatment plant in chennai at the lowest price. Metro water is delivered to homes through pipes from reservoirs, ponds, lakes and even from rivers which is nothing but stored rain water. Usually in stored rainwater as its rain, the water is generally pure from chemical contaminants but once it touches the ground it starts consuming the characters of the ground where the rain lands.
If we take Chennai City depends on Poondi with 3231 Mcft (Storage capacity), Cholavaram with 1081 Mcft, Redhills with 3300 Mcft & Chembarambakkam the highest with 3645 Mcft.
Though the water treatment is done the water quality in Chennai still remains a question mark as the piped water carries a lot of contaminants, as well as many areas pipes, are old and, in some areas, there is a mix of sewage water in the Metro water due to pipes that are broken in some places so it’s better to have a basic water treatment plant which we call as Over Head Tank filtration system.
Sometimes you can see red worms in metro water which usually gets piped during summer as the water is piped from the bottom-most part of reservoirs which is muddy, milkish, and contaminated.
Benefits of Over head Tank Filter :
Metro or Municipal Water Treatment
Things you need before you install a Over head tank filtration system
- You need a collection sump (storage tank at the below ground level)
- Need a motor that pushes the water from your sump to Overhead Tank
Muddy Water Treatment Solution
The best way to purify dirty or muddy water is to put a solution of Alum (Aluminium Sulphate) into the well directly in case of an open well or into the primary holding tank into which the borewell water is pumped. Alum is safe and is a flocculent used by almost all public water authorities for the primary settlement of sediment in the water and their water purification. You do not need to use too much. As a rough guide dissolve about 50 grams of Alum in about 5 to 10 liters of water in a bucket and pour it evenly over the surface of the well or the bore well-holding tank. 50 grams of Alum is more than sufficient for a well of up to about 6 meters (20 feet) diameter. For very small wells and holding tanks use about half the quantity. The water should become clear within 24 hours with almost all the mud and dirt settling to the bottom of the well or tank. In case your water has no other contaminants other than turbidity which was caused by the dirt and muddy water, then before using the water, run it through a simple cartridge filter, Sediment filter, and also to remove any odors and improve the taste of water. Also, install an Activated Carbon filter.
How does a Metro Water Treatment Filter Work?
During the service cycle water is treated by one or more processes. Processes include: separation, adsorption, and addition of sacrificial media to the water each having its specific place and purpose in treatment. Many Metro filters are specialized, designed to treat one water quality problem. A “filtration system” may have more than one filter, think multiple filters for multiple problems.
During the service cycle contaminants are filtered from the water as it flows through the media bed from the top to the bottom of the filter tank. If the filter did not have a mechanism for cleaning itself it would, over time, foul, plug up or otherwise stop working and fail. To prevent this from happening the control valve periodically directs the flow of water to clean the filter bed after which the filter is returned to service. This filter cleaning process.
WaterSparks Metro Water Treatment Filter provides fully cleaning operations, and it can continuously separate impurities from water and other liquids. The maintenance and operation of the metro water filter are very simple, even in the severe operating conditions it also can continue to keep running in a good condition.
Chlorine and slight sulfur odors can often be removed by a carbon filter unit. However, when odors are extreme, your water treatment professional may recommend a chemical feed system to help increase the life of a carbon unit. In such installations, this series of filters will effectively remove taste and odor associated with chlorine and sulfur.
Chlorine and slight sulfur odors can often be removed by a carbon filter unit. However, when odors are extreme, your water treatment professional may recommend a chemical feed system to help increase the life of a carbon unit. In such installations, this series of filters will effectively remove the taste and odor associated with chlorine and sulfur.
Ideal for treating acidic waters that can corrode a plumbing system.